The LE error in the Samsung washing machine is most often noticeable without accessing the scoreboard - through puddles on the floor. What are the causes of the leak and is it possible to independently solve the problem?
Root cause of failure
LE on the display indicates the current tank.
The manufacturer changed the error codes several times, for some models the sign LE1, E9 (in cars that entered the market before 2007) or LC says about the same problem. Fault codes are identical to each other.
Water from the machine when the hose is damaged is usually on the floor, the cause of the breakdown can be determined visually. But in rare cases, it is not possible to detect a malfunction by external signs: the washing machine looks good, although the display shows an error.
How is the fault determined?
If the pressure switch in a short period of time has detected a decrease in the volume of water in the machine more than four times, the washing will be stopped. In this case, the equipment shows the corresponding code on the display.
Stopping the washing machine if the drain hose is damaged allows you to avoid overheating of complex electronics. Replacing consumables will cost less than replacing a burned-out board.
Some models are equipped with an aquastop. In such units, a separate sensor controls the integrity of the tank and the level of water inlet. According to the principle of operation, it looks like a float and is located at the bottom of the washer. If the process of water intake and drainage is disturbed, the sump overflows the liquid, raising the sensor. The operation of the equipment is interrupted, and the washer shows an LE error.
What to do to do an independent repair
In some cases, it is possible to remove the LE error without a technician. We will figure out how to fix the problem with our own hands and what to do before calling the wizard.
Find a leak
The weak elements of the washing machine are hoses (for draining water and connecting the drum). The unit seal may also leak, which is damaged by small items that have fallen into the washing machine along with clothing during washing.
Inspect the hose
If a LEI error is displayed on a brand new washer, it is possible that the hose was not fastened tightly when connected. Correct installation is enough to clear errors.
A detailed understanding of what led to the malfunction and how to fix the problem will help the table.
Malfunction | Possible reasons | What to do |
Under the washing equipment there is water, LE is lit on the screen. | Mechanical damage to the seal cuff or water discharge pipe. | Small slots can be sealed, but more often you have to change the damaged part, which means calling the wizard. |
The wash does not start, when you try to start, a LE error appears. | Damage to the pressure switch. | If blowing a blockage in a part tube does not solve the problem, replacement is necessary. |
LE lights up when changing washing processes: switching to spin or rinse. | The electronic indicator circuit may fail. | It is often possible to solder a board and restore correct operation. If the processor burns out completely, you need to buy a new block. |
The Aquastop-equipped washing machine starts up, then throws the LE code. | There is a possibility of incorrect operation of the sensor with a working technique. | The item must be replaced. |
The washing machine leaks from the back, the display shows a LE error | The problem is with the hose. | Need a new consumable. |
The trouble indicator disappears for a while, then appears again. | Wiring of the washing machine fails - frayed, damaged or worn. | You can try to do a twist of wires or replace the cable with a new one. |
Basic equipment diagnostics can be performed independently. In most cases, it will be necessary to involve a specialist in repairing the unit.