When a malfunction occurs, the Hoover washing machine displays an error code on the display. Electromechanical models SM Hoover without a screen report a malfunction by blinking indicators.
Having looked at the table below, you will understand: what the error code means, what needs to be done and how to fix the situation without calling the wizard.
Hoover washer error table: causes and solutions
Error Codes(shows on the display) | LED blinking series (determines the number of flashes after a pause) | Error value | Code Reasons | How to troubleshoot |
E 01 | 1 | CM door is not tightly closed. Blocking Issues. | The door lock or a locking device (UBL) has failed. Faulty control module. |
|
E 02 | 2 | Problems with water intake. | If the code E 02 is lit on the board, there is probably a blockage in the filler system. The control unit may have failed. | To reset the error:
|
E 03 | 3 | When E 03 is lit, the AGR does not drain the water. |
|
|
E 04 | 4 | There was a problem with the water intake valve in the Hoover. | Damage to the filler valve. | To remove error E 04, check the filler valve. If there is a malfunction, a new valve is installed. |
E 05 | 5 | E 05 indicates that there is no heating of water. |
|
|
E 06 | 6 | E 06 - electronic unit error (EEPROM). Or the balance is disturbed during washing (imbalance). |
|
|
E 07 E 08 | 7-8 | Codes E 07 and E 08, depending on the model, say: the door lock is jammed, or the SMA engine is faulty. |
|
|
E 09 | 9 | Error motor washing. | The engine does not work, the impeller does not rotate. On the display gives an error code E 09, testing does not stop. | Damage to the triac or control board requires replacement. |
E 11 E 12 | 11-12 | Open circuit. | The wiring circuit between the electronic board and the heating element of the dryer is broken. | With signals E 11 and E 12, the connecting circuit is inspected, defective elements change. |
E 13 E 14 | 13-14 | E 13 and E 14 - error of the electronic module. Machine wash in cold water, no heating. | Malfunction of the heater (thermal sensor) or control unit. | The heating element and temperature sensor are checked. When parts break, new ones are installed. |
E 15 | 15 | If E 15 is lit on the board, the electronic module has failed. | The memory of the control board is damaged. | Replacing the electronic board. |
E 17 | 17 | Broken tachometer. | The board does not receive a signal from the tachogenerator and issues an E 17 code. | Inspection of the tachometer. Install a new device. |
E 18 | 18 | A failure has occurred in the electronic unit. | Module malfunction. | When E 18 appears, it is necessary to replace the electronic control unit. |
You have learned what each error code in the Hoover washing machine means. Having savvy in the field of self-repair, you will no longer be lost if an error is displayed on the panel.
Before checking, always unplug the machine.